Fuel © IEC 1997#3640FUEL INJECTION PRESSURETESTER KIT
22-3 Fuelb. Loosen the fuel tank cap to release any pressure from the fuel tank.c. MAKE SURE the ignition is off. Locate the fuel system’s test valve
TestingFuel 2-4p. Wrap a shop rag around test port areato avoid fuel spray and to absorbexcess fuel. CAREFULLY disconnectthe gauge hose from the port
22-5 FuelWARNING:Systems without test ports require that fuel lines beremoved or disconnected. Please be aware that these linesmay be UNDER PRESSURE,
TestingFuel 2-6l. Turn ignition off and follow the test and repair procedures to correct theproblem. After all necessary repairs have been completed,
33-1 Fuel3.1 LIMITED ONE YEAR WARRANTYThe Manufacturer warrants to the original purchaser that this unit is free ofdefects in materials and workmanshi
Warranty and ServiceFuel 3-2
© IEC 1997 FuelINNOVA ELECTRONICS CORPORATION17291 Mt. Herrmann StreetFountain Valley, CA 92708Printed in Taiwan
Table of Contentsi FuelParagraph Title Page No.GENERAL INFORMATION1.1 ABOUT THE TESTER ...
1 General InformationEngine 1-11.1 ABOUT THE TESTERThe Fuel Injection Pressure Tester Kit is designed to perform fuel pressuretests on most domestic a
11-2 Fuel6. Ford Adapter. Installs on the fuel system test port of Ford and someChrysler vehicles to allow connection of the tester.7, 8. Hose. 5/16&q
General InformationFuel 1-3a. Read and follow all safety precautions.b. Make sure the battery is fully charged and the vehicle has enough fuel inthe t
11-4 Fuelp. When placing the bleed-off hose into a container to collect excess fuel, makesure the container is approved for gasoline.q. When working o
General InformationFuel 1-5
22-1 Fuel2.1 GENERALThe tests outlined in this manual are for checking Throttle Body Fuel Injection(TBI) (see Figure 2) and Multi-port Fuel Injection
TestingFuel 2-2•The tee adapter is suitable for use with most fuel injection systemsequipped with rubber fuel hoses secured by fuel line clamps at the
Komentáře k této Příručce